Lawton Oklahoma French Drain, Norman, Yukon, Edmond, Mustang

Oklahoma Drainage and Sprinkler Repair 405 203 9419

French Drain Installation —   French Drains are designed to do a lot of things.  If you have an area that has unwanted water standing in it or running across it, a French Drain can be the answer.  A French Drain is a trench that runs across the Drainage Problem Area.  A French Drain Pipe is placed in the bottom of the trench.  The French Drain Pipe is perforated with thousands of small holes.  In most cases the Drain Pipe has a nylon soc around the pipe to act as a filter for the French Drain.  The French Drain trench is then filled with some type of small rock or stone.  We typically uses crushed 1 inch Lime Stone to cover the French Drain Pipe.  The dirt that was dug out of the trench is taken away or spread out around the French Drain.  The Lime Stone replaces the dirt and fills the French Drain Trench all the way to the surface.

Oklahoma Drainage and Sprinkler Repair 405 203 9419 — We provide:

    French Drain Installation, Surface Drain Installation, Drainage System Installation

    Sprinkler Repair for all aspects of Residential Sprinkler Systems

    Emergency Sprinkler Repair Service, AFTER HOURS AND WEEKENDS.

Drainage Systems, French Drains, Surface Drains, Channel Drains, Sump Pumps, Sprinkler Repair, with 26 years of experience. 

Installing Surface Drain in Driveway

Oklahoma Drainage and Sprinkler Repair Recently installed a Drainage System in Nichols Hills.  The Drainage System was made up of a 4 inch French Drain starting in the back yard.  It ran between the garage and the pool.  Several gutters were connected directly into the French Drain.  From this point, we expanded up to a larger 6 inch Drain pipe to handle the added water into the system from the gutters.  In several places the French Drain had to run through areas where Sprinkler Pipes were in the way.  We had to re-rout all the Sprinkler Pipes and Wires under the French Drain.

 

French Drain in Oklahoma City

Large 6 Inch French Drain Installed in Norman

When water come in contact with the French Drain, it seeps down through the stones and into the French Drain Pipe.  It then flows through the Drain Pipe to the exit point.  Typically a French Drain will have two possible exit points.   The First is called a “Pop-Up Emitter.”  It is a Green Lid on top of a release basin for the French Drain.

Popup Emitter to release water from a Drainage System in Yukon.

The second type of Exit Point for a French Drain is a “Curb Fitting.”  The Curb Fitting is installed through the curb going out into the street.  The French Drain Pipe runs to the Curb.  The curb is cut out and the Curb Fitting is cemented through the Curb.

Installing a Curb Fitting for a French Drain in Edmond

French Drains are designed to move large amounts of water.  A French Drain moves water away from the Drainage Problem area from the Surface like a large Surface Drain, But also below ground, or sub surface.  Most people don’t take into account the water that flows to a problem area underground.  Sub surface water flow is not eliminated by a Surface Drain.  A French Drain can move away water that is below the surface of the ground and drain away water that is on the surface.

 

Drainage System Installation in Norman